SAMSUNG DRYER TROUBLESHOOTING MANUAL FULL
SAMSUNG DRYER TROUBLESHOOTING MANUAL CODE

Do not overtighten because the coupling may be damaged.Ĥ. Using pliers, tighten the coupling an additional two-thirds turn. Connect the straight end of the water hose to the Y connector.ģ. Then, connect the female end of the Y connector to the cold water tap.Ģ. If you have a washer cold water hose attached to the cold water faucet, unscrew and remove the hose. The dryer must be connected to a cold water tap using the provided water hoses.ġ. Be careful not to scratch or damage the surface.Ĭonnect the water hose Samsung Dryer-Connect the water hose

The dryer has a high-gloss finish on the entire surface.

They can scratch or damage the top cover of the dryer.

Do not place any heavy or sharp objects or a detergent container on the dryer.

Protect the surface from sharp objects.

The external exhaust hood must be cleaned more frequently to ensure a proper air flow.

Check and clean the exhaust system on a yearly or regular basis to maintain optimum performance.

Stains may be still visible, but will not affect subsequent loads.

Tumble old towels or rags to remove any remaining stains or cleaning substances.

Remove any stains from the tumbler with an all-purpose cleaner.

Wipe up any spills or overspray immediately.

When using liquid cleaning agents, apply them to the cleaning cloth.

Some laundry pre-treatment soil and stain removers may damage the feature panel.

Do not spray liquid cleaning agents directly on the display of the dryer.

Empty the water tank, turn the power on, and restart.

SAMSUNG DRYER TROUBLESHOOTING MANUAL FULL

Water tank full Drain pump is out of order. Malfunction is detected in the motor relay circuit. The Thermistor2 resistance is very low or high. The Thermistor1 resistance is very low or high. The electronic control needs to be checked.

SAMSUNG DRYER TROUBLESHOOTING MANUAL CODE

If this information code remains, contact a Samsung service center.Įlectronic control problem (Invalid Communication). Make sure laundry is not caught in the door. If the problem continues call for service. If the problem continues call for service.Įeprom is not communicating properly.

Make a button is not being pressed continuously. Unit detects a button is being pressed for over 30secs or button is stuck. If the problem continues call for service.ĭoor is not closing properly.

Check for: PCB with eeprom circuit.Ĭlogged lint screen. (Communication error) Check for: Check PCB and wire harness. Check power supply.Įlectronic control problem. ( Over voltage error) Check for: - Check PCB and wire harness. Invalid power frequency sense circuit.Įlectronic control problem. Check for: - Not using regular power source frequency. Check for: - Display PCB key circuit short or not. Invalid state of key circuit short for 30 secs. Check for: Loose or open wire terminals in door sense circuit. Invalid door state for more than 256 milliseconds. Loose or open wire terminals in door sense circuit. Check for: - Close the door and run the dryer. Invalid heating temp in running the dryer. The termistor resistance is very low or high. An occurrence of an error will make a sound of error melody for 5sec and continuously show one of the error displays from the following errors.

Samsung dryer troubleshooting manual